Sidel SBO and Matrix Heater Modules: No Stress, Just a Perfect Fit
Getting PET preforms to that exact glass transition temperature is a balancing act. You need enough heat to make the plastic pliable, but not so much that you burn the surface and ruin the bottle. It’s a tight window. That’s why we build our heater modules specifically for Sidel systems—everything from the old-school SBO lines to the newer Matrix series. The “Drop-In” Promise Look, nobody wants to spend their weekend drilling new holes in a chassis or hunting for weird adapters. We’ve all been there. We made sure our modules match the original SBO and Matrix footprints exactly. You just pull the old one out and slide the new one in. The connectors are standard industrial gear, so you can wire them up and get moving without any custom work. It’s fast. Simple. Talking Heat and Wavelengths We use short-wave infrared tech because it punches through the PET wall quickly. By tweaking the quartz tube thickness and the filament density, we can dial in the heat flux just right. If you’re running high-speed blowing cycles, our high-wattage setups give you that rapid ramp-up you need to keep the line moving. One quick heads-up, though: if you go with the higher-output lamps, you’re putting more heat into the oven. If your cooling blowers are getting old, you might notice the ambient temperature creeping up. Just something to keep an eye on. Built for the Grind Production lines are brutal. They run 24/7, they get dirty, and they don’t forgive mistakes. We treat our quartz glass to fight off contamination. That stops those annoying “hot spots” from forming, which is usually what kills a lamp prematurely. Since we stick to the Sidel geometry, there’s no destructive installation. No machining. No wasted downtime. You just swap the modules and get back to work, keeping your cycle times exactly where they need to be.